Quote:
|
Originally Posted by aniceone2hold Ed, isnt it easier to drill new holes? That is what I was planning on doing. |
************************************************** ****
I might do that as well but for now I want to leave my options open besides some of the newer users might not want to try and center the router and drill the holes and countersinking.....
Now what are you going to do about a starter pin?
************************************************** ****
Sorry this might have been a little off subject for some of you.... but to make up for that check out the image..... The nuts go in holes on the ruter side of the sub-base. I used some tape to hold them in place. Another hint:
The table insert has a hole pattern that matches where the nuts go in the sub-base.
Now can you tell us the details?????
Ed