Hi Ed
Here's a snapshot one done free hand
but a little bit of mask tape on the fence and on the stock you can get them to come out space right on the button,the tape is cut at the same time and keeps the chip out down to a min. and it comes right off after.
By the way you can do the same thing if you are getting rip out on the edge of a board..
then go back and do one full pass to it clean it up..
=============
Quote:
Originally Posted by eball30263  I am relatively new to sign routing and I would like to add decorative edges (scallops) to some of my signs. I have seen these on some signs in sign shops. One fellow told me to use a cove bit and eyeball the scallops around the edges? Well I tried that with a cove bit, an ogee bit and a roundover bit. Although it gave the desired effect, the scallops were not spaced evenly. Any suggestions? Thanks |