Well Stan,, most of the joinery was just rabbits with glue, I did cheat and take the boards into work to cut the rabits for the glass shelfs out on a bridge port mill,,, because I wanted to make sure they were across from each other at the perfect hight,, but you could set up a jig and cut them with your router,,, but I was being lazy there,,, As far as the top trim peice is concerned, I cut out one half side on a piece of plywood and laid out both side from this piece so they would be the same,, and then cut it out with a portable jig saw to a rough size, leaving at least 1/8 inch from the line and then clamped on the plywood template and used a flush cut trim bit and finnished it off with a round over bit to ease the edge and give it a finnished looking edge............ and thank you for the comments.
__________________
Terry
It seems like every where I go,,,,,,,,,,,,,,,,,,,,,,,,, there I am...
|