I'm looking at buying the Mortise & Tenon System from Oak Park.(since it's on sale..) I currently have a Hitachi M12V mounted in the table; I also have a B&D RP200 1 3/4 HP 1/4" plunge router......
My question is will the B&D RP200 be OK(power wise/shank wise) for doing the mortising? Since I have this router, I would like to use it with the 7" base plate,[that comes with the Mortise & Tenon System] rather than switching out the M12V from the 11 " table plate to the 7" plate for mortising... Is the mortising done with a 1/4" bit as well?
All comments are welcome.....
