Router Forums - View Single Post

BrianS · 01-01-2006, 10:18 PM

I suppose it's a bit late, but I should have mentioned the small "spurs" on the outboard side of the bit. In looking at the bit, it appears that the inboard side of the spur is a cutting edge, as well as the bevelled edge at the end of the spade. Not sure if I have a file that small, but then the tool store is just down the road.

Thanks

Brian

01-01-2006, 10:18 PM	#4
BrianS Registered User Forum Geek Join Date: Nov 2004 Location: Windsor,Ontario Posts: 374 View BrianS's Gallery	Report This Post! I suppose it's a bit late, but I should have mentioned the small "spurs" on the outboard side of the bit. In looking at the bit, it appears that the inboard side of the spur is a cutting edge, as well as the bevelled edge at the end of the spade. Not sure if I have a file that small, but then the tool store is just down the road. Thanks Brian __________________ A married man should forget his mistakes. There's no use in two people remembering the same thing!
	Top - Reply with Quote