AndyGTC

Hi Bob & Mark,

Again, thanks for the friendly welcomes.

Yup, I'll post a picture certainly. Assuming it works of course!! I'm using the router's guidebush for this one but I can adapt it to actually mount the router on the jig via the router base if that doesn't work sufficiently well enough. I also plan on using one pin mounted through a sliding assembly with 2 rules either side to make sure that I'm accurate. With drum moulds you have to be very accurate due to the fact that if you're oversized things like heads (skins) and hoops won't fit and if you're undersized, the drum lugs will not align properly. Hopefully my variation on the jig will make this a lot easier. As with all these things there's a certain amount of trial and error and re-thinking involved! Still, it's fun planning and working it all out.