Router Forums - View Single Post

**BobandRick** · 10-20-2004, 06:15 PM

After jointing the material are the edges straight?

If your out on the two inches on either end might mean the router bit is exposed beyond the out-feed of the fence. check out the following tip

click here to see the jointing tip

10-20-2004, 06:15 PM	#2
BobandRick The Router Guys Forum King Join Date: Aug 2004 Posts: 632 View BobandRick's Gallery	Report This Post! After jointing the material are the edges straight? If your out on the two inches on either end might mean the router bit is exposed beyond the out-feed of the fence. check out the following tip click here to see the jointing tip __________________ Rick and Bob The Router Guys Click here to send a greeting card to friend or relative.
	Top - Reply with Quote