I was fortunately given many projects to do especially when I was refurbishing Executive aircraft which required a great variety of cutters, so I would have over 150 cutters in my posession (must make a count some day) many are duplicated as I used to purchase two of the same type to ensure I had a sharp one available for the process I was required to do. I did not have time to wait until they were returned from the Saw Doctor. The smallest cutter I have is 1.6mm diameter, and the largest is a Rounding over with an eliptical cut 25mm 1/2 minor axis approx. Just fitted into my Makita router which has a base opening of 64mm.
I only ever purchased a cutter as I needed it and I always purchased the better quality as I knew they would last longer. Also they produced a better cut. there are many people who have purchased sets of cutters and have still to use some of them.
I have purchased a great number of Face/Edge cutters as opposed to the bearing type since I learned the advantages of the Template Guides
Tom
Last edited by template tom; 09-22-2006 at 12:33 AM.
|