I have three routers so the routine is a little different for each one.
In all instances though I use a small
Shop Vac Hang-up. I currently have the blue one and it's been working so well I'm going to get the yellow one which has a little more capacity and power. I chose this unit because of it's very small footprint since my space is limited.
My router table has collection at the router and on the fence. I alternate depending in the bit and type of cut I'm doing. At some point I'd like to make a Y-connection so I can do both at the same time. Since my vac hose is 1 1/4" it's not always easy to find connectors and parts.
For handheld routing I use a DeWalt 621 with a built-in dust collection port. I also use a Hitachi M12SC router on an
EZ Smart guide system. I ordered a dust shroud for the Hitachi but haven't received it yet. I recently picked up a
Bosch dust collector attachment to mount on the underside of the router when doing edge work.
So far this system is working well for me. I'm not routing 8 hours a day so the smaller Shop Vacs are fine.
Michael