You're Welcome Rusty
I'm glad it helped, I also use it to get the parts of the door to match (wood grain thing) I will glue up stock to match sometimes and make 4 or 5 doors that are all the same wood that way,plus you don't need to use the sled sometimes because the stock is wide and you can make all the cope cuts at one time and then rip them to size.
Then make a male /female jig to put on the patten cut that can be a bit tricky on
1 1/2" wide stock.
Plastic push block that has a female (patten) screwed to the block so it will hold it down to the table and let you push it by the bit safe and a small 2 x 4 block to hold it to the fence.
Like the one below ▼
Note,,,, the cut outs can be 3/4" deep but make two or three blocks they are nice to have on hand.
Bj