Quote:
|
Originally Posted by bobj3 Hi Dan
I think I would stick with the plastic  BUT hears one more ideal pickup some 1" thick plastic drill out the center hole and the mouting holes then drill out the holes for the plunge rods then just drill the holes for the roll pins drive them into place and your done without using any glue 1" x 9" x 9" acrylic plastic should work just fine for this one.
Also, I think I would pickup the item(s) below just in case you need to get the bit higher in the router table. http://www.mlcswoodworking.com/shops...er_collet.html
Bj |
This is how I will probably do it if I make one.
Another thing I thought of is ordering a new replacement base then I could modify the base I have now.
But there is still the Horizontal panel bit that will do fine until I buy a new router.\
I am thinking of the Bosch 3.25 HP Electronic Plunge Router model 1619EVS
Dan