Ah Ha: I have the jig, and it works...... It was always there and I was using it wrong!
What was I doing wrong? I was using the out side as the guide for centering the bit. It worked good if I used 1/2 inch stock and 1/4 inch spiral bit. But if I tried 1 inch the it would not center. I purchased the series 4 DVD and he used it, then I noticed that the bearings were riding on the board u are mortizing, and not on the two support boards. The more I watch, the more I uderstand.
Thanx for the info
Bud
__________________
The Geezer
|