Router Forums - View Single Post

simplenik · 12-27-2006, 04:51 PM

Good day

I did try to make a glue joint on the router table with the 1/32" on the outfeed fence but it never worked for me.

So I went with something that is more "idiot proof" - straight edge.
Yes, it takes more time but, I'm an amateur and "time is not money"

The problem was the correct positioning of the straight edge, so I made small "positioning blocks" for 3/8" bit.

the example is made with Melamine boards.

Regards
niki

12-27-2006, 04:51 PM	#1
simplenik Registered User Join Date: Feb 2006 Posts: 228 View simplenik's Gallery	Report This Post! Jointing with hand router Good day I did try to make a glue joint on the router table with the 1/32" on the outfeed fence but it never worked for me. So I went with something that is more "idiot proof" - straight edge. Yes, it takes more time but, I'm an amateur and "time is not money" The problem was the correct positioning of the straight edge, so I made small "positioning blocks" for 3/8" bit. the example is made with Melamine boards. Regards niki Last edited by simplenik; 05-27-2007 at 11:01 PM.
	Top - Reply with Quote