Quote:
|
Originally Posted by challagan Thanks Bob! That Eagle bit looks like it would work with a 1/8 heigth of cutter and depth of cut. I wonder if the shank is long enough at 1 7/8 to get up to cut a box a 1/4 to 3/8 above the bottom of the box? You think this would work on the table and just run it around the inside of the box like that safely?
Corey |
Yep I think so
, plus you can use it for offsets letters (3D type) that would look neat also...on top of a box or sign.
The only draw back I can see, the box needs to be taped real tight b/4 you run the bit inside of the box,and then remove the tape so you can take it down and put in the base or top in.
The Bit would almost eliminate the error that I do all the time, going to far with slot or in the wrong spot and it shows on the outside of the box.
And I call myself dumb shit ,you did it again. LOL
Bj