Originally Posted by glassguy1456

Hello,
I am working on a project that is made of 5/8 inch stock and the 2 blocks (boxes??) would lend themselves to the dado-rabbit joint. (I could of made them from 3/4 using 3/8 bit and fence) but can I make it in 5/8 stock? (I should of planed them down to 1/2 prior to final sizing but I never thought of it at the time.) They are also only 8 inches long so too short to run through thickness planer....(I feel)
If someone can help out with size & type of bit, method etc. would be greatly appreciated.
Have a good day