 Routing patterns on a box lid
Corey, I don't know if I am missing something, but if I am doing a one-off, or several of the same at the one time with a non standard size commercial template these pics show my fast method, forget the length of the stock, it was too good to cut for the photo-shoot. Draw the X Y lines to assist centring the stock and template holder, pin four bits of scrap around stock, centre the holder and pin or screw four pieces of scrap to hold in position. We are now after only a few minutes, ready to insert the template, in this case a four way 3D one. I shall try to find a pic of something that I have done with this type of set-up. Harry |