Mike, check the compression pins that are in the fence, see if they've moved or the holes in the plates are slightly over round. If either case, that will not allow for proper depth of cut.
"The bit does have a height adjustment, it is set so the lowest cutter is 1/8" above the table. If this is not done all the geometry would be off. I picked up this information today from Rick."
Are we still talking about the depth of cut or the height or am I simply misunderstanding?
__________________
Ken www.CentralFiber.com
"A VETERAN"
"Whether active duty, retired, national guard or reserve - is someone who, at one point in their life, wrote a blank check made payable to "The United States of America", for an amount of "up to and including my life". That is HONOR, and there are way too many people in this country who no longer understand it." -Author Unknown
|