Thank you both George, Scott.
Well, I must say that I think it’s a madness for the prices these Sliding Compound Miter saws are going for. For another 100 or so, a person could have a good quality cast iron table saw.
As far as Makita LS1013L , that’s was my third choice if I consider a 10”. I’ve seen that for around 370.
If I wasn’t so afraid of using table saws, and too lazy to set it up properly, I think that would cover most operations and there would be no need for glide compound saw.
My concern is that can a table saw (with me operating it shakily and not setup 100%) produce as accurate angle cuts as a miter saw.
Maybe I should just get a nother router :-)
__________________ router è ancora il mio nome  |