 Inlay Guide Bushing and base plate
Hello, Doyle here.
Need some help.
I have a Porter Cable plunge router the plastic base plate of which will not center with the collet when the inlay guide bushing is in place. I would like to try my hand at an inlay, or two or three or more, just for practice before inlaying something in a project. The three screw holes in the plate are not large enough to allow centering the brass inlay gizmo with the inlay router bit. I have wiggled and jiggled, loosened and tightened every widget that I could put my fingers on, without success. The plastic base seems to center just fine. But with the guide bushing in place, centering with the inlay bit is all but impossible. Any idea will help.
Thanks in advance and take care.
Doyle |