Router Forums - View Single Post

Clem Wixted · 06-10-2007, 03:02 PM

My first post on this forum.

I would like to use the plastic edge trim that came off a floding table that got wet and the flake board is disintergrating.

What bit do I use to cut the thin groove in the new table top edge of the 3/4 plywood so I can tap the edge in? I don't know the real name of the plastic edging but it is 3/4 wide and is slightly curved on the face. The back has a thin grooved barbed protruding about 1/4 inch. This barbed protrusion goes into the groove in the table edge.

Any special things I should know before I do this?

Thanks,

Clem

06-10-2007, 03:02 PM	#1
Clem Wixted Registered User Join Date: Jun 2007 Location: Jonesboro, AR Posts: 6 View Clem Wixted's Gallery	Report This Post! What Router Bit for Table Edging? My first post on this forum. I would like to use the plastic edge trim that came off a floding table that got wet and the flake board is disintergrating. What bit do I use to cut the thin groove in the new table top edge of the 3/4 plywood so I can tap the edge in? I don't know the real name of the plastic edging but it is 3/4 wide and is slightly curved on the face. The back has a thin grooved barbed protruding about 1/4 inch. This barbed protrusion goes into the groove in the table edge. Any special things I should know before I do this? Thanks, Clem
	Top - Reply with Quote