Quote:
|
Originally Posted by bobj3 Hi Cowboy
Most cheap tables saws ,NO speed NO HP , thats' why may of them are taged 3HP
. . .
But why would you want to do that ? but Bob is right most can take it on (a S.C. device)
------ |
You no doubt know much more than I do about that first point --
I have no doubt you are correct.
All I can say for sure is that over about 10 years this little Delta has made a straight clean cut in or through everything I have thrown at it
- from pressure treated deck boards to 70 year old southern yellow pine - to oak - to hardibacker (cement board).
Heck -- it's like me -- it should have died a couple of times over.
So -- I reckon I'll keep using it til it does.
As for why I would want to connect it to a speed control ----
Well -- that was just one of those off the wall ideas that pass through your mind just before you go to sleep or just before you wake up --- or -- as in my case this morning -- when you are finding things to think about OTHER than your job :-)
It really wasn't anything thought out -
- the notion was to give it a softer start.
Now that I am a little more awake -- even I dont like the idea.