Thank you so much
Dave
I'm not "always thinking"...I sleep 5~6 hours a day...
Harry
I was thinking, maybe, instead of cutting the boards to "super precise" width and/or starting "exactly" on the line, I can cut them a little bit wider and then, trim them on the table saw.
I can even connect them one to the other (as on the last picture) and have a row of 4 boards and cut on the table saw to whichever lines I want...
Another thought that past through my mind is; I can glue 2 boards and 2 boards with this very thin double face tape, then, glue each couple one to the other with spacer and cut all the 4 boards in one shot...make one finger cut, turn the boards vertically 180° and cut the other side using the same stop setting.
Like that, I can finish cutting all the fingers, setting the stop only ones for each pass.
Regards
niki