Quote:
|
Originally Posted by bobj3 . . .
But on the other hand if one has a T-Slot setup it should be true to the front of the table top and run parallel to the bit, from one side to the other.. 
. . . |
Ok -- confused here (not uncommon on a Monday)
I'm guessing that was a typo?
Otherwise -- how can my t-slot be 'parallel to the bit' since
- as you point out -
the bit is a single point.
Honest question
not trying to be a smart aleck -
- and nik - not meaning to hijack your thread.
Just designing my first router table - which will include t-track.
Wanted to be sure I wasn't missing something.
Mind you - its been 35 years since I took geometry.