Router Forums - View Single Post

skinner · 07-05-2007, 01:21 AM

i am attempting to joint a few cedar boards prior to laminating them together to make a larger piece of furniture.
the cedar is one inch actual and I am using a half inch straight bit, however, when i get to the end of the board, the board gets too close to the bit which then cuts too deep, spoiling the whole effort.
I have closed up the opening to the bit but that still does not seem to help...any assistance to help me overcome this vexing problem will be greatly appreciated.

07-05-2007, 01:21 AM	#1
skinner Registered User New Member Join Date: Jul 2007 Posts: 2 View skinner's Gallery	Report This Post! router table problems i am attempting to joint a few cedar boards prior to laminating them together to make a larger piece of furniture. the cedar is one inch actual and I am using a half inch straight bit, however, when i get to the end of the board, the board gets too close to the bit which then cuts too deep, spoiling the whole effort. I have closed up the opening to the bit but that still does not seem to help...any assistance to help me overcome this vexing problem will be greatly appreciated.
	Top - Reply with Quote