The table insert is in...........Being the cheap ass, that I am. I had a hard time. I have harbor freight bits. The 1/2 inch, both the 1/4 and 1/2 inch shafts failed after 1/8th inch cuts. So I went an bought two good bits. Freud bits. Good-by Harborfreight.
I also found out that I would have been an outstanding carpenture in the 19th century. My house was built in 1895. It is two inchs out of square in 32 feet. My table top is square. I wa surprised at the results.
The insert wa placed 9 inchs from the left side and is 12 inchs from the front. I set it up for use with the INCRA jig.
Thanks to all that responded. I am now working on mounting the router mounting. It will take me a few days, as I have to look at it a lot.
Bud
__________________
The Geezer
|