Router Forums - View Single Post

simplenik · 07-08-2007, 02:23 AM

Good day

That's the latest version of the jig.

The setting might look very long (on the pics) but actually it's very short.

The "Fence stops" are set only one time.

The "Roller unit stops", two times (one for left and one for right) but it takes seconds.

On the test, I cranked the router up in increments of 1/8" but I felt that I could lift more for each pass (it was too easy for the router)

Regards
niki

07-08-2007, 02:23 AM	#1
simplenik Registered User Forum Geek Join Date: Feb 2006 Posts: 228 View simplenik's Gallery	Report This Post! Rolling Mortise jig for router table Good day That's the latest version of the jig. The setting might look very long (on the pics) but actually it's very short. The "Fence stops" are set only one time. The "Roller unit stops", two times (one for left and one for right) but it takes seconds. On the test, I cranked the router up in increments of 1/8" but I felt that I could lift more for each pass (it was too easy for the router) Regards niki
	Top - Reply with Quote