Hi Rolf
I must be a bit slow ,,,what I see is a jig that will work with one size of stock, that's to say if you are using 3/4" thick stock for the rails you will need to rework the jig big time to put the slots in a leg lets say...a 2" wide one..not to say anything about most 3/4" stock is not always the same...all the time..
.But it's neat jig to put the slots in the ends...
But if you use a only one clamp to hold the stock good chance it will slip when you put the down presser down to put the slot in...but I must be a bit slow on the up take of the jig..
==========
Quote:
|
Originally Posted by rmaxa Welcome to the forum John. There was an article in Fine Woodworking about one or two issues back that showed how to build a mortising jig. It made setup exact every time. I've attached a link to the video that shows how to use the jig. Hope this helps. http://www.taunton.com/finewoodworki....aspx?id=28696 |