BrianS

I know, I know... ANOTHER thread on dovetails.....


I've done a search of the messages and can't seem to find an answer to this one. I'm planning on making some drawers to be installed in an existing cabinet, and am wondering how to go about makeing a jig for the dovetail pins. I think that is the correct name for them. Spacing the dovetails doesn't look difficult, with a bit of practice of course, and a fabricated jig. Anyone have any suggestions on how to make the pins to fit into the dovetails? Setup is a table and 1/2" dovetail bit.

Thanks
Brian