Router Forums - View Single Post

**challagan** · 10-14-2007, 09:33 PM

As Roger says, you need to use a starting pin if you are not using a fence. This is a very common procedure on the router table but you can use a fence as well, just isolate the bearing so that the bearing doesn't touch the work piece.

Corey

10-14-2007, 09:33 PM	#3
challagan Retired Moderator Supreme Forum King Join Date: Feb 2006 Location: Iowa Posts: 4,002 View challagan's Gallery	Report This Post! As Roger says, you need to use a starting pin if you are not using a fence. This is a very common procedure on the router table but you can use a fence as well, just isolate the bearing so that the bearing doesn't touch the work piece. Corey __________________ My Carving Website: The Iowa Woodcarver http://iowacarver.tripod.com/ My Shop Website - Woodshop 51503 http://woodshop51503.tripod.com/
	Top - Reply with Quote