Hi, Kendall
I don't have a 2200E but I do have the Freud FT2000E mounted in one of the router tables on a 3/8" thick plate and it's works great BUT I did find using a bent wrench works best with this router,,, it lets me change the bits from the top side of the table,,,,you can buy one or just make your own..
http://www.sommerfeldtools.com/searc...=&c=wrench&t=s
I just recalled this
▼
Just a Note about the Freud router,, When I put the router in the table I found out if I lifted the router to high the round black plastic knob to adjust the height would push off the tube, so I said that sucks so I cut off about 3/4" of the threaded rod that's inside the tube,then it would go to the max without pushing the cap off....it's just a snap on cap part... I don't know if the 2200E is the same but you mant want to get the manual out and look at the parts list in the back to see if it's the same...3/4" is not that much but it will let it go to the max height...and just a bit more than the norm.
I guess you could just snap off the cap and try it and then just don't put it back on the tube if it works for you but just in case you want to take it down and fix it , see the URL below. it will help take it down,, by the way I still have the springs in mind...and it works fine in the table with them in place..
http://www.routerworkshop.com/mark1.html?list=ME05--
===========