Hi: The easy wayto make a zero clearance fence is to take a board that is higher than
the bit and thick enough to accomodate the bit circumference. Fasten the out put side of the board to the router table with a clamp. Turn on the router while keeping
the board clear of the bit, then move the infeed side of the board into the bit. The bit
will have cut its own outline into the board. Then all you have to do is set the board
(fence) where it will cut as you require. Put a clamp on the infeed side, and re-tighten the out feed clamp. That's all thats needed.
Hope this helps, Woodnut65 |