Again, no.
You see, I made a router table where the router mounts under the table like a standard router table and have an height adjustable plate mounted on the back of the table for horizontal routing, but the three little screws that hold the router are a pain to remove, then it,s a total pain to re-center the router and get all three to start threading in all the holes so it can be screwed down again.
It just takes too damn long to move it from one spot to the other, and to try and install it under the table is a total P.I.T.A!
I just wanted to twist the router 1/4 turn to pull it off the bottom, then twist it 1/4 turn to remount it on the back.