Hi jcmmgm
Reworking any template can be tricky,,, once you cut in to the template you can't repair it,,,
without doing alot of work...
I would suggest to just put it to one side and do it like the link below, then the hole for the plate will be dead on...
But besure to use a PATTERN bit ,that's a bit with the bearing under the cutter...on the shank...
http://wealdentool.com/acatalog/tips_20.html
==========
http://www.cmtusa.com/store/index1.i...routerbits.jpg http://www.cmtusa.com/store/index1.i...routerbits.jpg
========
http://www.routerforums.com/attachme...inges-8102.jpg
=========
how to make a template that fits your base plate..about a 5 min.job.
http://www.routerforums.com/50705-post43.html
=========
Quote:
|
Originally Posted by jcmmgm Hi, I bought a 9X13 aluminum plate and template from Rockler and I noticed that the radius on the template is not the same as the plate. Has anyone else ever run into this situation? If so, is there any way to modify the template so that I can solve the problem before I rout out my new table? Thank you all for your help. John. |