Hi reikimaster
With mortisers all you need to do is flip the stock over..because it has a fence it will come out dead on and you will not it blow it out on the back side as well...use it just like a hole saw ,cut from both sides when you can..
The sq. type pins are cool looking, just let them stick out, but round them off b/4 you hammer them in place with a small drive jig...that you can make with the mortisers,,,,2" x 2" x 6" long Oak, sq. hole in the end and you have a drive jig that will not damage the pin
=========
Quote:
|
Originally Posted by reikimaster Only problem I see with the mortisers for the drill press is that in THIS case, my mortises will be so deep that I don't think the mortiser will have near enough travel to get through the stock.
Unless I go with blind mortises and draw bolts or do draw bored dowels, in which case square dowels might be kinda cool. |