To review, I was trying to make a "cyma recta" profile, a sort of flattened Roman ogee, as part of a built-up crown molding. While several of you have asked me to post pictures, I have tried this evening, but nothing happens when I push the "upload" button, even after several minutes of waiting. I have sent a note to the webmaster asking what to try next. Any thoughts from those of you who have uploaded images?
I am happy to report that I was more successful in the shop than at the keyboard. I built a 30° fence of MDF and was able to complete my prototype molding in three steps: (1) run 1/2" thick stock past a 3/8" roundover bit (bearing removed) using the 30° fence; (2) run stock past a 3/8" cove bit (bearing removed) using standard fence and stock flat on table, leaving a tiny step where the profiles met, for fear of overcutting it; and (3) a little hand sanding with 220 to remove the step.
I know this means little without photos, and I will post them if/when I solve that problem. Thanks to all for your suggestions. This is my first thread on this forum, and I already have the impression that it is one of the friendliest forums out there! |