Checking the arbor for square is next, as well as the 90 and 45 degree blade angles. The arbor was dead on, but I had to adjust the 90 degree blade angle. Very easy to do from the top of the table.
The fence rails are next. The directions could have been a bit clearer here.
Took a while to figure out the placement of the rails.
Aligning the fence was simple. Adjust a couple nylon screws to tighten the fence, and check for parallel with the blade. It was also dead on out of the box. I set the zero on the guide and did a test cut. 4" was exactly 4".
Since I didn't install the outboard table, that will be tomorrows' job.
To be continued.