Hi Canman
I think Derek is talking about the jig below it can be used in many ways,slot cutter,trim bit and what you want to do BUT sometimes the router is not the right tool for the job , you may want to take a hard look at the table saw/radio arm saw/chop saw ,etc.for this job...
========
Quote:
|
Originally Posted by Canman Hi, I'm new to woodworking. I'm trying to mimic a plastic, two deck, playing card holder I saw. The sides are 60º and 1¼" deep. I purchased a lettering router bit that is 60º with a ¾" cutting depth, being that's all I could find. Would someone be able to tell me how to properly extend the angle down to the 1¼" depth? Would it be better to build a jig to hold the wood on an angle and use a straight cutter?
thanks. |