Hi Ed
" 1/4" collet router " I didn't know that .....but it's a old item from Sears and at that time they didn't have 1/2" ones ....or to say to many on the market place..
I try and use 1/2" shank bits in the one I have with a standard router base...
I don't know of any " tutorial videos " because it was made b/4 they did that
I have the manual but that's about it,,, and I did rework the indexing just a bit, I didn't care for the way they had it setup...didn't lock it down true...but now it's true for fluting...or slotting...I also don't round over the stock b/4 I chuck it up like many do on the table saw or band saw the jig is alot quicker...because the router is pulling off tons of stock in one turn of the crank...and it comes off clean and true....
NOTE when you said " video " it rang a bell this may help.
http://www.legacywoodworking.com/demoVideo.cfm http://legacywoodworking.com/techniques.cfm
=========