HI Julie
I would love to see a snapshot of the cove molding you made and like the one I posted ,I made a jig ( angle jig) to do it on the table saw and it was a nightmare for me, I started with a 3/4" x 3 1/2" wide 36" long pine and it was hoping all over the place by a 1/32" ,I tried 3 diff. blades and had the same error over and over not to say anyhting about saw marks,,,
After making some real nice pine firewood I gave up and use the bit below to get the job done with a pass or two on the router table...
Crown Molding Router Bits from MLCS
#7870 2-1/4" 1/2" $37.00 http://www.mlcswoodworking.com/shops...molding_anchor
=========
Quote:
|
Originally Posted by Julie I love my router but for this, I use the table saw. I just made some molding a few days ago out of pine and it is beautiful and hardly needed any sanding. I'm not sure why Bob said it was a 'nightmare' to make?
~Julie~ |