Hi Deck
I use a door size drop down table for assemby, it's hanging from the work bench with 3 hinges and is supported by one 2 x 2 sq.pole that holds just about anything I put on the table...assembly table is always a PIA ,,and I'm a collector of junk boxes,jars,spray cans you name it gets stuck on the work bench BUT the drop down table stops me from doing that once it's down it's clean
and ready for the next assemby job...room in most shops is always hard to come by and the drop down table takes care of that need for me, like you from time to time I need to get the truck in the shop ..
I also have a plate that's inlayed for the pocket hole system to make it easy and quick to put things together,,, I just hate to work on the floor, my floor in the shop is not level but the drop down table is...
In the snapshots below you will see a green ironing board under the top it's no longer in place because it was not needed for support, the table top is the same height as my table saw,router table.RAS,etc. so I can use it for a out feed or infeed table also...
========