Quote:
|
Originally Posted by rprice54 So I'm about to try out my newest set of bits. I bought a rail/stile bit set and a vertical panel bit from Rockler. I only have a 1 3/4HP Porter Cable router and didn't think it could handle a horizontal bit.
I know a lot of the horizontal bits have a back-cutter. I figure I can use a rabbeting bit for the same effect on the back of the panel to keep it flush with the front of the door frame, but what if I just plane the panels down an extra 1/8" (or whatever the depth is needed to keep them flush). I figure I can control the width of the edge of the panel by how many passes I make with the vertical bit. I will plane them first to be sure they don't tip over in the planer.
Any experience with this method? I just thought it would be quicker to run each panel through the planer a couple of extra times instead of rabbeting all 4 sides of each panel.
EDIT: while we're at it, what speed should I run the bit at? It's still pretty big. http://www.rockler.com/product.cfm?O...Select=Details
Door Set: http://www.rockler.com/product.cfm?O...Select=Details |
It looks like that vertical bit is for making a raised panel in 3/4" stock with a 1/4" tongue. This will make the panel proud of the frame in the front and recessed in back which is perfectly acceptable unless you are running the finished doors through a drum sander. If you reduce the panel thickness or set the fence to leave a 3/8" tongue with the intent of making a separate back cut you will reduce the amount of profile on the face to the point that it may not look correct.