Router Forums - View Single Post

Johnny Dee · 01-21-2005, 10:06 PM

I saw in the book Router Majic by Bill Hylton a jig that could be used to cut tennons but the only problem is that It did not say what bit you should use, Do I use a straight bit, a dado?

Also who makes a good set of cope & stick bits as well as a raised panel bit?

01-21-2005, 10:06 PM	#1
Johnny Dee Registered User New Member Join Date: Jan 2005 Posts: 3 View Johnny Dee's Gallery	Report This Post! What bit do I use for cutting tenons I saw in the book Router Majic by Bill Hylton a jig that could be used to cut tennons but the only problem is that It did not say what bit you should use, Do I use a straight bit, a dado? Also who makes a good set of cope & stick bits as well as a raised panel bit?
	Top - Reply with Quote