All things being equal/ new perfect as in router bit “Freud or whiteside “then correct speed( excluding bit size) setting is determined by feed rate and feed rate is determined by the type of material and or type of wood.
Example, if you take 4 , ˝ straight router bits ( which going by the book) would require a slightly lower than highest setting and run these at steady speed each through Mahogany, walnut, oak and dreaded mdf , You would get completely different results.
Hence, type of material + feed rate = proper speed setting taking into consideration the bit size.
Everyone knows that you can’t swing a 3 inch router bit at max speed.
__________________ router č ancora il mio nome  |