Quote:
Originally Posted by bobj3  Hi dwwilson44
The key is the BRASS , unlike steel the screw will grab the brass or to say put in a small dent in the brass , you can always just retap the screw hole to a SAE size unlike the metic one that's in it now...the next size up is just a bit bigger by just a little bit......if the ring is still lose just make a gasket out of some thin cardboard and place it under the ring...then lock in down in place..
======== |
bobj3 You pushed me over the edge on desiding to get this .that will work . I wanted to use my Frued1700 with the PC dovetail jig whitch has its special guide bushing , and it 2-1/4 hp. , and for 11.00+ not a bad loss if it dont work . Thanks
