| ||||||
It appears you aren’t a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If you’re an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!| This is a discussion on cnc router within the CNC Routing forums, part of the Routers category; Hi group, Tried to search previous posts but found nothing. I'm in the process of ... |
New Reply |
| | LinkBack | Thread Tools | Display Modes |
03-26-2005, 09:46 PM
| #1 (permalink) | ||
| Registered User |
Hi group, Tried to search previous posts but found nothing. I'm in the process of bidding on a computer controlled router for cutting 1/2" acrylic pieces to make electrolysis cells out of. Am I crazy to think that I'm going to be able to slow a router down enough to avoid melting the acrylic when cutting 1/8" x 6" grooves in 1/2" acrylic. Also am I going to be able to cut the sides all the way through (1/2") in one pass with a router or will I need to saw the sides? Thanks for your expertise. Great forum! Emmett | ||
|
|
Sponsored Advertisement - Register now to remove this advertisement.
|
|
** Please be sure to read our Disclaimer at the bottom of the page. **
These advertisements are only displayed to guests, register now for your FREE account on the worlds largest router and woodworking community! |
New Reply |
| Bookmarks |
| ||||||
It appears you aren’t a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If you’re an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mixing Bosch 1617 Router fixed base with Craftsman professional router | sf_basilix | Starting Off | 17 | 10-11-2012 05:20 PM |
| Motorized Router Lift - Eagle Lake Style | johnwnixon | Table-mounted Routing | 14 | 05-23-2012 04:51 PM |
| New Router my way | reible | General Routing | 20 | 11-30-2011 11:18 AM |
| RouterForums.com and Oak-Park.com - September 2006 Contest - VOTING STAGE!! | Mark | Contests Archive | 13 | 11-05-2006 02:23 AM |
| RouterForums.com and Oak-Park.com - September 2006 Contest!! | Mark | Contests Archive | 72 | 10-01-2006 12:02 PM |
cnc router 
Linear Mode
