bobj3

Hi Harry

Just giving you a bad time
It's a very nice LATHE job

Here's a quick tip,,, once you view one of your post you will see a number Like the #4 in the right hand corner of the post, click on it ,,, it will open just that post,,, once it's open and you are looking at it copy the URL address and then open NotePad and paste it in,,,then you have the URL ,then once you make a new post you can open NotePad and copy the line you put in,,,and just paste it in place
...
It's best to have a short cut in your task bar for NiotePad so you can get to it quick without closing down any other windows...BUT don't put a shortcut on the desktop for NotePad it will give windows a fit....and popup many error in the OS .

Can't tell you why but it will ..

It can be hard sometimes to get the shortcut in the quick task bar but do this ,select send to a Desktop shortcut, then drag the shortcut to the taskbar ,once you have that done remove the one on put on the desktop and your set.
Remember to use the right mouse buttom for most of the commands in windows...




=========

__________________
PodCast videos
RWS on YouTube

http://www.routerforums.com/86898-post1.html
Besure and click on the Up Arrow key ▲ on the Youtube video, you can select other youtube videos on router tables
http://www.woodworkingonline.com/?s=dovetail
Machine Cut ▼
http://www.woodworkingonline.com/200...cut-dovetails/

http://www.woodworkingonline.com/woo...podcast-store/

http://www.woodshopdemos.com/menu2.htm

Bob J.

Advertising

harrysin

Thanks for that info. Bj. I have printed it out and will try it out probably tomorrow when I hope to post the making of the two templates for the lid pattern and hopefully also showing the routing steps. Have a great day, I'm off to bed, it's 11.30pm over here.

__________________
Harry

harrysin

Once again, thanks for the refresher course Bj., how's this?

http://www.routerforums.com/40472-post1.html

__________________
Harry