| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| General Routing General Routing is a place to discuss the general operations of the router. This is where we talk about the routers that are still in the box, or the first router bit, what is a table-mounted and/or Portable routers. |
New Reply |
| | Thread Tools | Display Modes |
03-14-2006, 07:56 PM
| #1 |
| Registered User New Member |  Routing a decorative groove on an inside curve How can I make a decorative groove on a table apron that has an inside curve? Even with an edge guide I think there it would be hard to keep the groove parallel with the edge. Any suggestions? |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
03-14-2006, 10:08 PM
| #2 | |
| Registered User Forum King | Quote:
| |
|
| Top - Reply with Quote |
|
03-15-2006, 04:43 PM
| #3 |
| Registered User New Member | This is a rectangular table with aprons about 4 inches deep. At the bottom of each apron is a decorative up-curve. I want to make a groove along the flat front of each apron about 3/8 to 1/2 inch up from the curved edge. |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Routing out inside of a 3/4 x 2 x 4 | DavePowers | General Routing | 5 | 04-14-2008 09:43 AM |
| Routing a decorative edge on the inside of a faceframe? | Woodworker 52 | Portable Routing | 2 | 01-29-2008 02:00 PM |
| Curved Groove Routing ? | Jackalope | Jigs and Fixtures | 4 | 03-10-2005 04:29 PM |
| Help on Inside Corner Routing | aquarium-builder | General Routing | 6 | 01-06-2005 03:43 PM |
Linear Mode
