| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
05-20-2008, 04:24 PM
| #1 |
| Registered User Jr. Member |  New 3/8" policarbonate doesnt flat Hi, Here my New 3/8" policarbonate from ROCKLER, isnīt flat, Can i use or fix it ???   Thks and regards, |
| Top - Reply with Quote |
 Sponsor Post
| |
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |
|
05-20-2008, 05:01 PM
| #2 |
| Registered User Supreme Forum King | Contact Rockler. Perhaps they would exchange or replace it. I'm not sure there is much that can be done to correct this.
__________________ Ken (On temporary leave of abscense) "A VETERAN" "Wether active duty, retired, national guard or reserve - is someone who, at one point in their life, wrote a blank check made payable to "The United States of America", for an amount of "up to and including my life". That is HONOR, and there are way too many people in this country who no longer understand it." -Author Unknown |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for a FLAT SUB-BASE for PC894PK | Benny LaBaw | General Routing | 48 | 10-25-2007 12:53 PM |
| Flat side of base plunge base | Noddy | General Routing | 2 | 09-11-2007 10:30 AM |
| Routing out a flat surface | VictorM | General Routing | 5 | 11-19-2005 11:04 AM |
| Hand planing a panel flat | Dimitri Guest | Tools and Woodworking | 6 | 10-29-2004 07:45 AM |
Linear Mode
