Help
Require Assistance? Read the Beginners Guide to RouterForums.com
RouterForums.com - Router and Woodworking Discussion Community

Go Back   Router Forums > Router Forums > Introductions
IconIt appears you arenít a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If youíre an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!

ZenBot Setup

This is a discussion on ZenBot Setup within the Introductions forums, part of the Router Forums category; I just bought a used ZenBot 24x24. Using Vcarve Pro with Mach3. I have managed ...


  • Replies: 1, Views: 299

New Reply
 
LinkBack Thread Tools Display Modes
Old 11-09-2012, 12:33 PM   #1 (permalink)
Registered User
 
Join Date: Nov 2012
Country: United States
First Name: Dennis
Posts: 1
burgeswith1s is on a distinguished road

Default ZenBot Setup
Report Post Report This Post!

I just bought a used ZenBot 24x24. Using Vcarve Pro with Mach3. I have managed to get the machine to understand little of what I try to tell it. I know nothing and no one I have found in my rather remote area uses this combination. I will be asking lots of questions.

burgeswith1s is offline  
Sponsored Advertisement - Register now to remove this advertisement.
** Please be sure to read our Disclaimer at the bottom of the page. **
These advertisements are only displayed to guests, register now for your FREE account on the worlds largest router and woodworking community!
Old 11-09-2012, 04:24 PM   #2 (permalink)
Moderation Team
 
jw2170's Avatar
 
Join Date: Jan 2008
Country: Australia
First Name: James
Posts: 14,822
jw2170 is a jewel in the rough

Send a message via Skype™ to jw2170
Default
Report Post Report This Post!

Welcome to the forum, Dennis.

I would suggest you place an particular questions in the CNC section of the forum. many readers only look in their section of interest.
__________________
James
Sydney, Australia
.

I don't mind if other members disagree with my comments.
I don't profess to know everything, and I may learn something new.





jw2170 is online now  
New Reply

Bookmarks

Go Back   Router Forums > Router Forums > Introductions
IconIt appears you arenít a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If youíre an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!

Tags
mach3, zenbot


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
selecting routers for a 2-3 head setup Dan L General Routing 3 12-26-2010 10:19 AM
DT Bit Setup Blocks RoyBullets Jigs and Fixtures 10 09-17-2010 07:14 AM
How to setup a Finger Joint Assembly Router Bit Bychen Router Bits - Types and Usage 14 12-19-2009 02:18 PM
Permanent Dado Setup arkwood General Routing 4 11-12-2009 06:50 PM
Oak Park Mitre Gauge - Need Setup Help.. Chris H Jigs and Fixtures 3 07-06-2008 10:39 PM