timothy

Hello

Need some help. I have many lenghts of 3/4" thin wall pvc that I need to slice a 1/2" slot down the middle of so that I can snap them over a 1/2" steel pipe. I have made a jig to hold the pvc and tried to use a router but all it did was chip and crack the pipe. Was it the speed of the router? Type of material, or perhaps the bit? Please help if you can. Thanks in advance!

Advertising

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Router Forums

Hamlin

Hi, you may wish to hold the router still, (clamp in a vise of some sort), move the pipe over the bit. What type of bit are you using... straight, spiral? I prefer spirals.

__________________
Ken

(On temporary leave of abscense)

"A VETERAN"
"Wether active duty, retired, national guard or reserve - is someone who, at one point in their life, wrote a blank check made payable to "The United States of America", for an amount of "up to and including my life". That is HONOR, and there are way too many people in this country who no longer understand it." -Author Unknown

bobj3

Hi Tim

Sounds like it needs a bit of inside support ,,,(so it can't flex) I would try some dowel rod down the PVC pipe then tape the ends up so the dowel can move out of the pipe..until you have the pass done also just a small cut say about 1/8" deep..

You can also use a pair of 3/32" slot cutters on the same shaft to get the 1/2" wide slot...( on the router table) but again only 1/8" deep...

===============

__________________
Router Tables plans FREE, plus more
http://www.absolutelyfreeplans.com/W...p_projects.htm

Router Tip Archive
http://www.routerworkshop.com/router_tip_glossary.html

Calculators
http://www.routerforums.com/dynamic-calculators/

DougO

Don't know if you have a bandsaw, but I cut a slot down the length of PVC pipe on mine. Just put a fence 1/2" (or whatever you need) from blade and then run the pipe through the blade. Worked fine, zero tearout.

__________________
Doug

timothy

I tried that but there was to much movement in the pipe I could not get a clean cut.
Thanks
Timothy

timothy

I am unable to do that because it leaves a sharp edge.

Mike

Timothy, to make this work you must consider the forces exerted on the tubing. You need to get a small section of 4" x 4" perhaps 6" long. Drill a hole through it sideways that the PVC will just fit through. Clamp it to your fence and raise your bit up through it for the desired cut. Next you will need a dowel to fill the PVC from end to end. As you pass the PVC through the hole your cut will remove the material and the dowel and hole will keep it from shifting. Once finished remove the dowel and insert it in the next pipe. This method will guarantee uniform cuts.

__________________
Mike